International Research Journal of Innovations in Engineering and Technology - IRJIET International Open Access, Monthly, Peer Reviewed, Reputed Journal ISSN (online): 2581-3048

Impact Factor (2025): 6.9

DOI Prefix: 10.47001/IRJIET

Fabrication of Metal Chips Briquetting Machine

Murugkar A.DStudent, D.V.V.P College of Engineering, Ahmednagar, Maharashtra, IndiaKanore AniketStudent, D.V.V.P College of Engineering, Ahmednagar, Maharashtra, IndiaNagale PriyankaStudent, D.V.V.P College of Engineering, Ahmednagar, Maharashtra, IndiaD.K.NannawareProfessor, D.V.V.P College of Engineering, Ahmednagar, Maharashtra, India

Vol 2 No 3 (2018): Volume 2, Issue 3, May 2018 | Pages: 40-45

International Research Journal of Innovations in Engineering and Technology

OPEN ACCESS | Research Article | Published Date: 07-05-2019

doi Logo

pdf iconFull Text PDF
Abstract

Metal chips are widely recycled and used to form metals further. The handling, storage and transportation are an important aspect in recycling process. This project mainly focuses on the fabrication of metal chips briquetting machine for compaction and creation of metal chips briquettes for ease in handling and transportation. The briquettes are made by applying hydraulic pressure with the help of hydraulic cylinder. No heating unit is used to reduce the overall cost of the project. Storage capacity and transportation cost before and after forming the briquettes is been compared.

Keywords

Metal Chips, Briquetting Machine, Fabrication, hydraulic cylinder


Citation of this Article
Licence Copyright (c) 2026 International Research Journal of Innovations in Engineering and Technology creative common licence This work is licensed under Creative common Attribution Non Commercial 4.0 Internation Licence
References
  1. Milan Brozek, Alexandra Novakova, “Briquetting of Chips from Nonferrous Metal” Engineering for Rural Development, 2010.
  2. Eric Maynard, “Ten Steps to an Effective Bin Design” American Institute of Chemical Engineers, November 2013.
  3. J. Bridgewater and A.M.Scott, “Flow of Solids in Bunkers”, in the Handbook of Fluids in Motion.
  4. N.P/Cheremisinoff and R.Guptaeds, Butterworth, Ann Arbor, Chapter 31, 807-846, 1983.
  5. Ana Socalici, TeodorHeput, Erika Ardelean, Marius Ardelean, “Ferrous Waste Processing by Pelletizing Briquetting and Mechanically Mixed” International Journal of Energy and Environment, Issue 4, Volume2.
  6. Pramod R, G B Veeresh Kumar and Prashanth B, “Design and fabrication of Metal Briquette Machine for Shop floor. 

Copyright @ 2026 IRJIET. All Right Reserved.

Licensed underCreative Commons Attribution 4.0 International License.