International Research Journal of Innovations in Engineering and Technology - IRJIET International Open Access, Monthly, Peer Reviewed, Reputed Journal ISSN (online): 2581-3048

Impact Factor (2025): 6.9

DOI Prefix: 10.47001/IRJIET

Optimization of the Product Yields of the Pyrolysis of Palm Kernel Shell in a Fixed-Bed Reactor Using Response Surface Methodology (RSM)

Abstract

Pyrolysis is a method used for the thermo-chemical conversion of biomass and agro wastes into three major by-products namely, biochar, bio-oil, and biogas in the absence of oxygen. Global waste generation is increasing at an alarming rate. Palm kernel shell (PKS) is among the palm wastes accumulating in many palm oil mills around the globe with the attendant problems in waste management. The utilization of coal for energy generation is more expensive and not environmentally friendly. Bio-oil refineries and industries require the utilization of minimum resources (input) to achieve optimal response (output) in the production process.  However, more than 30% of the energy content derivation from the pyrolysis process is wasted due to non-optimization of the process parameters. This study investigated the optimization of the product yields of the pyrolysis of PKS in a fixed-bed batch reactor using response surface methodology (RSM). Masses of 1 kg, 2 kg, and 3 kg were pyrolyzed in batches at process temperature variations of 200 OC, 300 OC, 400 OC, and 500 OC. Design Expert 12 software (Version 12.0.3.0 Stat-Ease Inc. MN, USA) and Analysis of Variance (ANOVA) were used for the statistical analysis. Lack-of-fit, adjusted, and predicted multiple correlation coefficients and coefficient of variation of the different polynomial models were compared to select the best-fitting polynomial model. The optimal feedstock parameters were 2.66 kg of PKS and 410.0 OC process temperature. The predicted results were 0.986 kg of biochar, 1.205 kg of bio-oil, 0.481 kg of biogas, 1116.5 cm3 of bio-oil, and 140.6 minutes. The experimental results were 0.894 kg of biochar, 1.316 kg of bio-oil, 0.498 kg of biogas, 1208.9 cm3 of bio-oil, and at 162.8 minutes through validation. The validated quadratic model was suitable for the optimization and RSM is a numerical, statistical, and mathematical tool for modeling and optimization of the pyrolysis process in a fixed-bed batch reactor.

Country : Nigeria

1 Joseph O. O.2 Akinola A. O.3 Ogedengbe T. I.4 Akinnuli B. O.

  1. Department of Mechanical Engineering, Federal Polytechnic, Ilaro, Nigeria & Department of Mechanical Engineering, Federal University of Technology, Akure, Nigeria
  2. Department of Mechanical Engineering, Federal University of Technology, Akure, Nigeria
  3. Department of Mechanical Engineering, Federal University of Technology, Akure, Nigeria
  4. Department of Industrial and Production Engineering, Federal University of Technology, Akure, Nigeria

IRJIET, Volume 8, Issue 3, March 2024 pp. 155-166

doi.org/10.47001/IRJIET/2024.803021

Full Paper
Download

References

  1. Gupta S., Mondal P., Borugadda V.B., Dalai A.K. (2021). Advances in upgradation of pyrolysis bio-oil and biochar towards improvement in bio-refinery economics: A comprehensive review, Environmental Technology & Innovation, 21: (2021), 101276, ISSN 2352-1864, https://doi.org/10.1016/j.eti.2020.101276.
  2. Aziz M. A., Rahman M. A., and Halim M. H. (2018): Design, fabrication, and performance test of a fixed bed batch type pyrolysis plant with scrap tire in Bangladesh. Journal of Radiation Research and Applied Sciences. 11: 311–316. https://doi.org/10.1016/j.jrras.2018.05.001.
  3. Akinola, A. O. (2016): Evaluation of the Efficiency of Thermochemical Reactor for Wood Pyrolysis. European Journal of Engineering and Technology, 4(4): 17-24. ISSN 2056-5860.
  4. Mushtaq, F., Abdullah, T. A., Mat, R. and Ani, F. N. (2015): Optimization and characterization of bio-oil produced by microwave-assisted pyrolysis of oil palm shell waste biomass with microwave absorber. Bioresource Technology, 190(1); 442–450. https://doi.org/10.1016/j.biortech.2015.02.055.
  5. Kabir, G., Mohd-Din, A. T. and Hameed, B. H. (2018): Pyrolysis of oil palm mesocarp fiber catalyzed with steel slag-derived zeolite for bio-oil production. Bioresource Technology, 249(1): 42-48. https://doi.org/10.1016/j.biortech.2017.09.190.
  6. Poudel J, Ohm T., Gu J.H., Shin M.C., and Oh S.C. (2017). Comparative study of torrefaction of empty fruit bunches and palm kernel shell, Journal of Material Cycles and Waste Management, https://www.springerprofessional.de/comparative-study-of-torrefaction-of-empty-fruit-bunches-and-pal/10035138.
  7. Joseph O.O. (2022): The Design and Construction of a Mobile Waste Incinerator for Agro Combustible Wastes. International Journal of Scientific & Engineering Research, 13(12): 662-676. ISSN 2229-5518. IJSER © 2022 http://www.ijser.org.
  8. Jamaliddin, A.M., Ismail, K., Ishak, M.A.M., Ab Ghani, Z., Abdullah, M.F., Safian, M.T., Idris, S.S., Tahiruddin, S., Yunus, M.F.M., Hakimi, N.I.N.M. (2013): Microwave-assisted pyrolysis of palm kernel shell; Optimization using response surface methodology (RSM), Renewable Energy, 55: 357-365. www.elsevier.com/locate/renene. http://dxx.doi.org/10.1016/j.renene.2012.12.042.
  9. Fakeye, A. B. and Oyedepo, S.O. (2019): Designing Optimized Organic Rankine Cycles Systems for Waste Heat-to-Power Conversion of Gas Turbine Flue Gases, International Conference on Engineering for Sustainable World. Journal of Physics: Conference Series 1378 (2019) 032097. IOP Publishing. doi:10.1088/1742-6596/1378/3/032097.
  10. Soyemi, J. and Hammed, M. (2019): Handling Mobile Network Congestion with Assembly line Control Algorithm, International Journal of Computer Science and Information Security (IJCSIS), 17(2):  February 2019.
  11. Ahmad R., Hamidin N., Ali U. F. M., and Abidin C. Z. A. (2014): Characterization of bio-oil from palm kernel shell pyrolysis. Journal of Mechanical Engineering and Sciences (JMES), 7: 1134–1140. ISSN (Print): 2289-4659; e-ISSN: 2231-8380. DOI: http://dx.doi.org/10.15282/jmes.7.2014.12.0110.
  12. Angelo J. R., Marion C., and Johann G. (2014): Fast pyrolysis of low and high ash paper waste sludge: Influence of reactor temperature and pellet size; www.elsevier.com/locate/jaap; http//dx.doi.org/10.1016/j.jaap.2014.12.010.
  13. Ukonu, C.U and Makanjuola, J.O. (2019).  -Optimization of Biogas Yield from Co-Digestion of Sawdust and Cow Dung under Anaerobic Condition Using Chinese Fixed Dome Bioreactor (CFDB), Federal Polytechnic Ilaro-Journal of Pure and Applied Science, 1(1): 45-51, 2019. ISSN: 2714-253145.
  14. Rodriguez, J., Lustosa Filho, J., Melo, L., de Assis, I., and de Oliveira, T. (2020): Influence of pyrolysis temperature and feedstock on the properties of biochars produced from agricultural and industrial wastes. Journal of Analytical Applied Pyrolysis, 149: 104839. doi: 10.1016/j.jaap.2020.104839.
  15. Ogunkanmi J. O., Kulla D. M., Omisanya N.O., Sumaila M, Obada D.O., Dodoo-Arhin D. (2018). Extraction of bio-oil during pyrolysis of locally sourced palm kernel shells: Effect of process parameters, Case Studies in Thermal Engineering, 12: 711-716, ISSN 2214-157X, https://doi.org/10.1016/j.csite.2018.09.003.
  16. Garcia-Nunez J. A., Pelaez-Samaniego M. R., Garcia-Perez M. E., Fonts I., Abrego J., Westerhof, R. J. M. and Garcia-Perez M. (2017): Historical Developments of Pyrolysis Reactors: A Review. Energy and Fuels, 31(6): 5751–5775. https://doi.org/10.1021/acs.energyfuels.7b00641.
  17. Asadullah, M., Ab Rasid, N. S., Syed A., and Azdarpour, K. A. (2013): Production and detailed characterization of bio-oil from fast pyrolysis of palm kernel shell. Biomass and Bioenergy, 59: 316-324.
  18. Morero B., Groppelli E. S., and Campanella E. A. (2017): Evaluation of biogas upgrading technologies using a response surface methodology for process simulation, Journal of Cleaner Production, 141: 978-988, ISSN 0959-6526, https://doi.org/10.1016/j.jclepro.2016.09.167.
  19. Imran M., Hussain S., Mehmood K., Saeed Z., Parvaiz M., Younas U., Nadeem H. A., Ghalani S.P. and Saleem S. (2021). Optimization of Ecofriendly Synthesis of Ag Nanoparticles by Linum usitatissimum Hydrogel using Response Surface Methodology and its Biological Applications, Materials Today Communications, 29: 2021, 102789, ISSN 2352-4928, https://doi.org/10.1016/j.mtcomm.2021.102789.
  20. Box, G. E. P., and Draper, N. R. (2007): Response Surfaces Mixtures and Ridge Analyses. (2nd Ed.), John Wiley & Sons, Inc.:  ISBN: 978-0-470-05357-7.
  21. Mehmood T., Ahmeda, A., Ahmada, A., Ahmadb, M. S. and Sandhuc, M. A. (2018). Optimization of mixed surfactants-based β-carotene nanoemulsions using response surface methodology: An ultrasonic homogenization approach, Food Chemistry, 253: 179–184.
  22. Dirgantara, M., Karelius, Cahyana, B.T., Suastika, K.G., and RM Akbar, A. (2020): Effect of Temperature and Residence Time Torrefaction Palm Kernel Shell on the Calorific Value and Energy Yield. The 4th International Conference on Applied Physics and Materials Application, 18–20 September 2019, North Sumatera Province, Indonesia, Journal of Physics: Conference Series,  1428: 012010. DOI 10.1088/1742-6596/1428/1/012010.
  23. Ma T., Wang Q. and Wu H. (2010).  Optimization of extraction conditions for improving the solubility of peanut protein concentrates by response surface methodology, LWT Food Science and Technology, 43(9):1450-1455, DOI: 10.1016/j.lwt.2010.03.015.
  24. Qarizada, D., Mohammadian1, E., Alias, A. B., Rahimi, H. A., and Yusuf, S. B. (2018): Effect of temperature on bio-oil fractions of palm kernel shell thermal distillation. International Journal of Innovative Research and Scientific Studies, 1(2): 34-39.
  25. Rashid, F., Ahmed, Z., Ameer, K. et al. Optimization of polysaccharides-based nanoemulsion using response surface methodology and application to improve postharvest storage of apple (Malus domestica). Food Measure 14, 2676–2688 (2020). https://doi.org/10.1007/s11694-020-00514-0.
  26. Karelius K., Dirgantara M., Rumbang N., Kristian N. and Purwanto F. (2020).  Increasing product quality of torrefied palm kernel shell batch model with internal surface area modification, IOP Conference Series: Materials Science and Engineering, Volume 980, 1st International Conference on Science and Technology for Sustainable Industry (ICSTSI 2020) 6-7 August 2020, Banjarbaru, Indonesia, DOI 10.1088/1757-899X/980/1/012061.
  27. Luga E. and Atis C. D. (2018). Optimization of heat cured fly ash/slag blend geopolymer mortars designed by ‘‘Combined Design” method: Part 1, Construction and Building Materials, 178 (2018) 393–404, https://doi.org/10.1016/j.conbuildmat.2018.05.140, 0950-0618/Ó 2018 Elsevier.
  28. Bako H. K., IbeoguH. I., Bassey A. P., Yar M. S., Zhou T., and Li C. (2023). Optimization and characterization of double emulsion derived from rice starch, rice protein isolates, and rice bran oil, International Journal of Biological Macromolecules, 258(2) 2024, 128966, ISSN 0141-8130, https://doi.org/10.1016/j.ijbiomac.2023.128966.

Copyright @ 2026-2017 IRJIET. All Right Reserved.

Developed by Byzero Technologies